ESPA OL: P`GINA 19FRAN˙AISE : PAGE 3910" Compound Slide Miter SawInstructionManualPart No. 897462-001The Model and Serial No. plate is located on
10WORK CLAMP OPERATION1. The height of the work clamp (A) Fig. 22, can beadjusted by loosening lock knob (B) and moving post (C)up or down, or depress
11ADJUSTING SLIDING FIT BETWEENTRUNNION AND BEVEL BRACKETAf ter a long period of time it may become necessary toadjust the sliding fit between the tru
12ADJUSTING BLADE GUARD1.After an extended period of time, the movable blade guard (A) Fig. 32, might become sloppy and moveerratically when the cutti
13TOOLSTORAGEA clip is provided on the rear of the saw and provides a convenientstorage area for wrench (A) Fig. 35, as shown.FASTENING THE SAW TO A W
14OPERATIONCORRECT OPERATING PROCEDURE FOR SLIDE CUTTINGW ARNING: SLIDE CUTTING BY PULLING THE SAW TO WARDS THE OPERATOR CAN BEDANGEROUS, CAUSING THE
15USING SAW AS A CHOP SAWWhen cutting material that is narrow enough to allow the saw blade to cut through in a chopping motion (similarto a conventio
16NOTE: The piece of crown moulding used for the out side corner will always be on the right hand side ofthe blade, as shown at (A) Fig. 47. The piec
174. Remove arbor screw (E) Fig. 52, by turning screw(E) clockwise while at the same time pressing in on arborlock (F) Fig. 53, to keep arbor from tur
18KEEP TOOL CLEANPeriodically blow out all air p assages with dry compressed air. Clean all plastic p art s with a sof t damp cloth.NEVER use solvents
The following are trademarks of PORTER-CABLE Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.) (Les marques suivantes sont desm
IMPORTANT SAFETY INSTRUCTIONSW ARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk offire, electr
320. DANGER: KEEP HANDS AW AY FROM CUTTING AREA. Keep hands away from blades. Do not reachunderneath work while blade is rot ating. Do not attempt to
418. NEVER recut small pieces.19. PROVIDE ADEQUATE SUPPORT to the sides of the saw t able for long workpieces.20. NEVER use the miter saw in an area w
OPERATING INSTRUCTIONSFOREWORDPorter-Cable Model 3807 is a high capacity 10" compound miter saw designed to cut wood and non-ferrousme t als. It
6MOVING CUTTINGHEAD TO THE REAR POSITION1. MAKE CERTAIN THE MACHINE IS DISCON-NECTED FROM THE POWER SOURCE.2. Carefully remove cable tie (A) Fig. 4, w
7ASSEMBLYW ARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWERSOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ
8ASSEMBLING WORK CLAMP1. Insert post (A) Fig. 14, of work clamp assembly (B)down through hole in the base of the machine as shownand lock in place by
9ADJUSTING SLIDING FIT BETWEENM O VABLE TABLE AND BASECAUTION: DISCONNECT THE MACHINE FROMTHE POWER SOURCE.If it ever becomes necessary to adjust the
Comments to this Manuals