Porter-cable 352VS User Manual download pdf (Page 6)

4. WORK IN ONE ROOM AT A TIME. Furnishings should be removed or

placed in the center of the room and covered. Work areas should be

sealed off from the rest of the dwelling by sealing doorways with drop

cloths.

5. CHILDREN, PREGNANT, OR POTENTIALLY PREGNANT women and

nursing mothers should not be present in the work area until the work is

done and all cleanup is complete.

6. WEAR A DUST RESPIRATOR or a dual filter (dust and fume) respirator

mask which has been approved by the Occupational Safety and Health

Administration (OSHA), the National Institute of Safety and Health

(NIOSH), or the United States Bureau of Mines. These masks and

replaceable filters are readily available at major hardware stores. Be sure

the mask fits. Beards and facial hair may keep the masks from sealing

properly. Change filters often. DISPOSABLE PAPER MASKS ARE NOT

ADEQUATE.

7. KEEP FOOD AND DRINK out of the work area. Wash hands, arms, and

face and rinse mouth before eating or drinking. Do not smoke or chew

gum or tobacco in the work area.

8. CLEAN UP ALL REMOVED PAINT and dust by wet mopping the floors.

Use a wet cloth to clean all walls, sills and any other surfaces where

paint or dust is clinging. DO NOT SWEEP, DRY DUST OR VACUUM.

Use a high phosphate detergent or trisodium (TSP) to wash and mop

areas.

9. AT THE END OF EACH WORK SESSION, put the paint chips and debris

in a double plastic bag, close it with tape or twist ties and dispose

properly.

10. REMOVE PROTECTIVE CLOTHING and work shoes in the work area to

avoid carrying dust into the rest of the dwelling. Wash work clothes

separately. Wipe shoes off with a wet rag, then wash that rag with the

work clothes. Wash hair and body thoroughly with soap and water.

REPLACEMENT PARTS

When servicing, use only identical replacement parts.

MOTOR

Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60

cycle A.C. current and voltage within plus or minus 5 percent of that shown

on the specification plate on the tool. Several models, however, are designed

for A.C. current only. Refer to the specification plate on your tool for proper

voltage and current rating.

Do not operate your tool on a current on which the voltage is

not within correct limits. Do not operate tools rated A.C. only

on D.C. current. To do so may seriously damage the tool.

EXTENSION CORD SELECTION

If an extension cord is used, make sure the conductor size is large enough to

prevent excessive voltage drop which will cause loss of power and possible

motor damage. A table of recommended extension cord sizes will be found

in this section. This table is based on limiting line voltage drop to 5 volts (10

volts for 230 volts) at 150% of rated amperes.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Comments to this Manuals

No comments

Porter-cable 352VS User Manual Page 6

Comments to this Manuals

Related products and manuals for Grinding machines Porter-cable 352VS