Porter-Cable PIN100 Installation Guide download pdf (Page 7)

PREPARING THE TOOL

1. After reading and understanding this entire manual, connect tool to

air supply (Fig. 18).

DANGER: Never point tool at yourself or others in work area.

Always connect tool to air supply before loading fasteners (Fig. 18).

Do not load fasteners with trigger depressed.

Only use approved Porter-Cable fasteners.

Operator and others in work area MUST wear safety glasses with side

shields. Always wear ANSI Z87.1 approved safety glasses, and hearing

protection when preparing or operating the tool.

Never use a tool that is leaking air, has missing or damaged parts, or

requires repair.

2. Turn tool upside down, depress latch (1) Fig. 19 and slide magazine

cover (2) Fig. 19 open. Make certain the secondary trigger (B) Fig. 19 has

locked out the primary trigger (A) Fig. 19 to prevent unintentional actuation.

The magazine cover must be completely retracted to insure engagement of

pin height adjustment feature.

3. Insert a strip of approved fasteners (A) Fig. 20. Make certain the

direction arrow printed on the

fasteners is pointed up as shown.

NOTE: The direction arrow must

point in the same direction as the

pins will be driven.

4. Push magazine cover closed as

shown in Fig. 21. Make certain cover

snaps in place.

5. Observe pin reload indicator

access hole (A) Fig. 22 to know when

fastener supply is low.

•

Fig. 18

Fig. 19

➞➞

Fig. 20

Fig. 21

➞➞

Fig. 22

903607- 01-23-02.qxd 1/29/02 12:51 PM Page 7

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Porter-Cable PIN100 Installation Guide Page 7