InstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces below and retain for futu
1090° AND 45° BEVEL POSITIVE STOPSThe saw is equipped with adjustable positive stops at both 90° (A) Fig. 6,and 45° (B) Fig. 6. It is recommended that
11TO ADJUST 90° POSITIVE STOP1. DISCONNECT TOOL FROM POWER SOURCE.2. Set bevel stop sleeve to normal position (see Fig. 6).3. Loosen bevel adjustment
12BLADE WRENCH STORAGEBlade wrench storage is provided in the bottom of the saw handle (see Fig. 10). Position the handle end of the blade wrench into
13RIP GUIDEA rip guide (A), Fig. 13, isavailable as an accessory.Install rip guide as follows:1.DISCONNECT TOOL FROMPOWER SOURCE.2. Insert rip guide t
14Do not force the cut. Let the saw do the cutting at the rate of speedpermitted by the type of cut and the material being cut. When the cut iscomplet
15KEEP TOOL CLEANPeriodically blow out all air passages with dry compressed air. All plasticparts should be cleaned with a soft damp cloth. NEVER use
16A complete line of accessories is available from your Porter-Cable•Delta Supplier, Porter-Cable•Delta Factory Service Centers, and Porter-Cable Auth
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des
2SAFETY GUIDELINES - DEFINITIONSindicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.indicates a
33. Do not expose power tools to rain or wet conditions. Water enteringa power tool will increase the risk of electric shock.4. Do not abuse the cord.
4ADDITIONAL SPECIFIC SAFETY RULESSERVICE1. Tool service must be performed only by qualified repair personnel.Service or maintenance performed by unqua
5 When the blade is pinched or bound tightly by the kerf closing down,the blade stalls and the motor reaction drives the unit rapidly backtoward the
6EXTENSION CORD SELECTIONIf an extension cord is used, make sure the conductor size is large enough toprevent excessive voltage drop which will cause
7Length of Cord in Feet115V 25 Ft. 50 Ft. 100 Ft. 150 Ft. 200 Ft. 250 Ft. 300 Ft. 400 Ft. 500 Ft.230V 50 Ft. 100 Ft. 200 Ft. 300 Ft. 400 Ft. 500 Ft. 6
84. Remove blade retaining bolt, release blade lock and remove outer bladeflange.5. Retract telescoping guard and remove blade.INSTALLING THE BLADE1.
9TO ADJUST DEPTH OF CUT FOR NORMAL CUTTINGIt is recommended that the depth of cut be adjusted so that the saw bladejust protrudes through the thicknes
Comments to this Manuals