Porter-Cable 6602 User Manual download pdf (Page 9)

SERVICING THE ECCENTRIC BEARING (see Fig. 4)

NOTE: For model 6602 only, Model 6604 does not require this service.

Once every three months, depending

upon usage, remove the shear head

from the power unit following the

instructions in the REPLACING

CUTTERS section of the manual.

CAUTION: DISCONNECT TOOL

FROM POWER SOURCE

BEFORE DISASSEMBLING.

Put a few drops of heavy oil on the

eccentric bearing assembly (A) Fig. 4,

so that it saturates the needle bearing. The outside surface of the eccentric

bearing ring and the yoke of the center blade should be coated with bearing

lubricant.

SERVICE AND REPAIRS

All quality tools will eventually require servicing or replacement of parts due

to wear from normal use. These operations, including brush inspection and

replacement, should ONLY be performed by either an AUTHORIZED

PORTER-CABLE SERVICE STATION or a PORTER-CABLE/DELTA

FACTORY SERVICE CENTER. All repairs made by these agencies are fully

guaranteed against defective material and workmanship. We cannot

guarantee repairs made or attempted by anyone other than these agencies.

Should you have any questions about your tool, feel free to write us at any

time. In any communications, please give all information shown on the

nameplate of your tool (model number, type, serial number, etc.).

ACCESSORIES

A complete line of accessories is available from your Porter-Cable •

Delta Supplier, Porter-Cable • Delta Factory Service Centers, and

Porter-Cable Authorized Service Stations. Please visit our Web Site

www.porter-cable.com for a catalog or for the name of your nearest

supplier.

WARNING: Since accessories other than those offered by Porter-Cable

• Delta have not been tested with this product, use of such accessories

could be hazardous. For

safest operation, only Porter-Cable •

Delta

recommended accessories should be used with this product.

Fig. 4

900276 - 10-31-01.qxd 2/13/02 8:33 AM Page 9

1 2 3 4 5 6 7 8 9 10 11

No comments

Porter-Cable 6602 User Manual Page 9