Porter-cable H1000IS-W User Manual download pdf (Page 11)

16. To make installation easier, submerge handle grips into warm soapy water.

Remove handle grips from soapy water and slide onto handles.

17. Squeeze snap button (12), slide into handle, and

release snap button through second hole.

NOTE: V of snap button is inserted first. Repeat

step on other handle.

18. Depress snap button (12), slide into handle

bracket, and release through first slot in handle bracket as shown. Secure

handle to handle bracket with screw (6) and locknut.

19. On other handle depress snap button (12), slide into handle bracket, and

release through first slot in handle bracket as shown. Secure handle to

handle bracket with screw (6) and locknut.

20. Attach handle bracket assemblies to frame with screws and locknuts (7).

Tighten securely.

NOTE: Orientation of handle assemblies to frame will depend on how the

operator wishes to operate snap button (12). If snap button is assembled

to outside of the generator frame it will be operated by the fingers. If snap

button is assembled to inside of the generator frame it will be operated by

the thumbs. The figure shows the snap button assembled to inside of

generator frame.

Risk of moving parts. Keep fingers away from

all moving parts. Contact with moving parts

can result in serious injury. Keep children away from the

generator at all times. They may not be able to recognize the

hazards of this product.

21. The portability kit is now ready for use.

22. To lower handle, depress snap button and fold handles down.

23. Raise handles and allow snap button to snap into place.

11- ENG

A01296

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Porter-cable H1000IS-W User Manual Page 11