Porter-cable 330 User Manual

InstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces below and retain for futu

10Any loss of power before the above maintenance check may indicate theneed for immediate servicing of your tool. DO NOT CONTINUE TO OPERATETOOL UNDER

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2WARNING: SOME DUST CREATED BY POWER SANDING, SAWING,GRINDING, DRILLING, AND OTHER CONSTRUCTION ACTIVITIEScontains chemicals known to cause cancer, bi

32. Dress properly. Do not wear loose clothing or jewelry. Contain longhair. Keep your hair, clothing, and gloves away from moving parts.Loose clothes

4SPECIFIC SAFETY RULES AND SYMBOLS1. HOLD TOOL BY INSULATED GRIPPING SURFACES WHENPERFORMING AN OPERATION WHERE THE CUTTING TOOL MAYCONTACT HIDDEN WIR

... watertight construction…/min ... revolutions or reciprocation per minuteADDITIONAL SAFETY RULES FOR PAIN

6REPLACEMENT PARTSWhen servicing use only identical replacement parts.MOTORMany Porter-Cable tools will operate on either D.C., or single phase 25 to

In general, coarser grit sizes will remove the most material and finer grit sizeswill produce the best finishes.Naturally, in all sanding operations,

84. While holding sander firmly and offof work surface, slide switch (A), Fig. 3,to the “ON” position.5. Allow sander to reach full speed.Set it down

9wide, overlapping arcs. Do not concentrate on small areas. If liquid removersor heaters are used to speed the work, be sure the surface is cool and d