Porter-Cable 691 Use and Care Manual

InstructionmanualThe Model and Serial No. plate is located on themain housing of the tool. Record these numbers inthe spaces below and retain for futu

10ATTACHING THE MOTOR1. DISCONNECTBOTH POWER CORDS (base andmotor) FROM POWER SOURCE.2. Loosen the clamp screw (A),Fig. 3 to set the power unit in the

11NOTE: Setting the index line to 1/4" on the ring means the cutting edge of thebit is exposed 1/4" below the base.ADJUSTING SUB-BASE ALIGNM

12To allow the tool to run without continually pressing the trigger (C), Fig. 8,press the trigger (C) into the handle and engage the switch locking bu

13To install, insert templet guide in center hole in router base and secure inplace with the locknut.BEFORE CONNECTING ROUTER TO POWER SOURCE: Install

14A complete line of accessories is available from your Porter-Cable•DeltaSupplier, Porter-Cable•Delta Factory Service Centers, and Porter-CableAuthor

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Les marquessuivantes sont des

2Read and understand all warnings and operating instructionsbefore using any tool or equipment. When using tools or equipment, basic safetyprecaution

3Some dust created by power sanding, sawing, grinding, drilling,and other construction activities contains chemicals known (to theState of California)

4Read all instructions. Failure to follow allinstructions listed below may result in electric shock, fire and/orserious injury. The term "power t

5d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may resu

61. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Con

7SYMBOL DEFINITIONV ... voltsA ... amperesHz ... hertzW ... wattsk

8EXTENSION CORD SELECTIONIf an extension cord is used, make sure the conductor size is large enough toprevent excessive voltage drop which will cause

9SELECTING THE BITThe 691 comes furnished with two collets which can accept bits with 1/4" and1/2" diameter shanks. A3/8” collet is availabl