CORDLESS BRADNAILERInstructionmanualThe Model and Serial No. plate is located on themagazine of the tool. Record these numbers in thespaces below and
OPERATIONUSING THE TOOLComplete all steps of PREPARING THE TOOL before using the tool.To fasten, move switch (A) Fig. 19 to desired position, grip too
11WARNING: Disconnect tool from air supply and/or remove batterybefore performing maintenance, clearing a jammed fastener, leavingwork area, moving to
12CLEARING A JAMMED FASTENER1. WARNING: Disconnect tool from air supply and/or remove battery.2. Open magazine and remove any remaining fasteners (see
13BATTERY OPERATIONCHARGING THE BATTERY PACK GENERAL Before using your cordless Nailer for the first time, the battery pack shouldbe fully charged. If
14DIAGNOSTICSThe Porter-Cable Charger is equipped with a diagnostic system thatautomatically checks the battery pack each time a pack is inserted into
MAINTENANCECLEAN AND INSPECT DAILYWARNING: Disconnect tool from air supply and/or remove batterybefore cleaning and inspection. Correct all problems b
TROUBLESHOOTINGWARNING: Disconnect tool from air supply and/or remove batterybefore performing any Service Procedure.SYMPTOM PROBLEMS SOLUTIONS1. Air
17PORTER-CABLE LIMITED ONE YEAR WARRANTYPorter-Cable warrants its nailing and stapling tools for a period of one year from the date of originalpurchas
18NOTES901891 - 08-31-01.qxd 2/13/02 11:53 AM Page 18
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des
GENERAL SAFETY RULESWARNING: When using pneumatic tools, basic safety precautionsshould always be followed to reduce the risk of personal injury. Fail
39. THE TOOL COMES EQUIPPED WITHTWIN POWER SOURCE TECHNOLOGY(TPS)™. DISCONNECT TOOL FROM AIRSUPPLY HOSE AND/OR REMOVEBATTERY before doing tool mainte
417. REMOVE FINGER FROM TRIGGERwhen not driving fasteners. Never carry toolwith finger on trigger. Fig. 10.18. DON’T OVERREACH. Keep properfooting and
5WORK AREA1. Keep your work area clean and well lit. Cluttered benches and darkareas invite accidents.2. Do not operate power tools in explosive atmos
67. Check for misalignment or binding of moving parts, breakage ofparts, and any other condition that may affect the tool’s operation. Ifdamaged, have
72. Before using a battery charger, read all instructions and cautionarymarkings on (1) battery charger, (2) battery pack, and (3) product usingbatter
819. Dispose of expended batteries properly.Porter-Cable Battery Packs contain rechargeable,nickel-cadmium batteries. These batteries must berecycled
9All compressed air contains moisture and other contaminates that aredetrimental to internal components of the tool. When using external air, an airli
Comments to this Manuals