Porter-Cable PC1800HV User Manual download pdf (Page 7)

BAD BATTERY

The charger can detect a weak or damaged battery. The LED flashes in the

pattern indicated on the label. If you see this bad battery blink pattern, do not

continue to charge the battery. Return it to a service center or a collection site for

recycling.

HOT/COLD PACK DELAY

When the charger detects a battery that is excessively hot or excessively cold, it

automatically starts a Hot/Cold Pack Delay, suspending charging until the battery

has normalized. After this happens, the charger automatically switches to the Pack

Charging mode. This feature ensures maximum battery life. The light flashes in the

pattern indicated on the label.

PROBLEM POWER LINE

When the charger is used with some portable power sources such as generators

or sources that convert DC to AC, the charger may temporarily suspend operation.

The LED flashes in the pattern indicated on the label. This indicates that the power

source is out of limits.

LEAVING THE BATTERY IN THE CHARGER

The charger and battery pack can be left connected with the LED glowing indefinitely.

The charger will keep the battery pack fresh and fully charged. This charger features an

automatic tune-up mode which equals or balances the individual cells in the battery pack

to allow it to function at peak capacity. Battery packs should be tuned up weekly or

whenever the battery no longer delivers the same amount of work. To use the automatic

tune-up mode, place the battery pack in the charger and leave it for at least 8 hours.

IMPORTANT CHARGING NOTES

1. Longest life and best performance can be obtained if the battery pack is charged when

the air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the battery

pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is

important and will prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to touch while charging. This is a

normal condition, and does not indicate a problem. To facilitate the cooling of the battery

pack after use, avoid placing the charger or battery pack in a warm environment such as

in a metal shed, or an uninsulated trailer.

3. If the battery pack does not charge properly:

a. Check current at receptacle by plugging in a lamp or other appliance

b. Check to see if receptacle is connected to a light switch which turns power off

when you turn out the lights.

c. Move charger and battery pack to a location where the surrounding air

temperature is approximately 65°F - 75°F (18°- 24°C).

d. If charging problems persist, take the tool, battery pack and charger to your

local service center.

4. The battery pack should be recharged when it fails to produce sufficient power on jobs

which were easily done previously. DO NOT CONTINUE to use under these conditions.

Follow the charging procedure. You may also charge a partially used pack whenever you

desire with no adverse affect on the battery pack.

5. Foreign materials of a conductive nature such as, but not limited to, steel wool,

aluminum foil, or any buildup of metallic particles should be kept away from charger

cavities. Always unplug the charger from the power supply when there is no battery pack

in the cavity. Unplug charger before attempting to clean.

6. Do not freeze or immerse charger in water or any other liquid.

Shock hazard. Do not allow any liquid to get inside charger.Never attempt

to open the battery pack for any reason. If the plastic housing of the battery pack breaks or

cracks, return to a service center for recycling.

INSTALLING AND REMOVING THE BATTERY PACK FROM THE TOOL

Make certain the lock-off button is engaged to prevent switch actuation

before removing or installing battery.

90550095 PC1800HV 4/1/09 1:25 PM Page 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Porter-Cable PC1800HV User Manual Page 7

Comments to this Manuals