Porter-Cable PCFP12234 Installation Guide download pdf (Page 5)

-5-

TOOL OPERATION

EYE PROTECTION which conforms to ANSI specifications and provides protection against flying particles both from the

RONT and SIDE should ALWAYS be worn by the operator and others in the work area when connecting to air supply,

loading, operating or servicing this tool. Eye protection is required to guard against flying fasteners and debris, which

could cause severe eye injury.

The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform to the

requirements of the American National Standards Institute, ANSI Z87.1/CAN/CSA Z94.3 and provide both frontal and side

protection. NOTE: Non-side shielded spectacles and face shields alone do not provide adequate protection.

BEFORE HANDLING OR OPERATING THIS TOOL:

EAD AND UNDERSTAND THE WARNINGS CONTAINED IN THIS MANUAL.

PORTER CABLE OFFERS ONE TYPE OF OPERATION FOR THE TS056 SERIES TOOLS, TRIGGER OPERATION WITH SECONDARY TRIGGER

OPERATION

TRIGGER OPERATION WITH A SECONDARY TRIGGER:

When the secondary trigger is pulled, the tool will actuate each time the trigger is pulled. This trigger operated tool is operated by first pulling or grasping

the secondary trigger under the hand grip, followed by pulling the trigger under the valve as shown Fig. 5.

Never inadvertently pull or grasp the secondary trigger when moving about, changing work location, when holstering or

hanging tool, or when preparing work surface for fastening operation.

The operator must not hold the secondary trigger pulled except during fastening operation as serious injury could result

if the trigger accidentally contacts someone or something, causing the tool to cycle.

FASTENER JAM CLEARING

ALWAYS DISCONNECT THE TOOL FROM AIR SUPPLY BEFORE CLEARING A JAMMED FASTENER.

TO CLEAR A JAMMED FASTENER:

1. Release the magazine and pull it back.

2. Remove Jammed fastener

Always disconnect tool from air supply when making adjustments or servicing.

The operator must not hold the secondary trigger pulled except during fastening operation as serious injury could result if the trigger

accidentally contacts someone or something, causing the tool to cycle.

Never inadvertently pull or grasp the secondary trigger when moving about, changing work location, when holstering or hanging

tool, or when preparing work surface for fastening operation.

TOOL OPERATION CHECK:

Remove all fasteners from tool before performing tool operation check.

TRIGGER OPERATION WITH A SECONDARY TRIGGER:

The trigger will only actuate the tool if the secondary trigger has already been pulled.

The secondary trigger is located under the handle. The secondary trigger prevents the primary trigger from actuating the tool if the secondary trigger

has not been pulled first.

PULL OR GRASP THIS SECONDARY

TRIGGER FIRST

PULL TRIGGER

Fig.5

TOOL OPERATION

OPERATION

FASTENER JAM CLEARING

TOOL OPERATION CHECK

USING THE OPTIONAL BELT HOOK (SOLD SEPARATELY)

1 2 3 4 5 6 7 8 9 10 ... 54 55

Comments to this Manuals

No comments

Porter-Cable PCFP12234 Installation Guide Page 5

Comments to this Manuals

Related products and manuals for Air compressors Porter-Cable PCFP12234