Porter-Cable FC350B Use and Care Manual download pdf (Page 10)

10 - ENG

 

The contact actuation trigger is intended for rapid

fastening on flat, stationary surfaces.

Using the contact actuation trigger, two methods are

available: 





1. Depress the contact trip against the work surface.

2. Pull the trigger to drive the fastener.

3. Allow the tool to recoil off the work surface





1. Pull the trigger.

2. Depress the contact trip against the work surface. As long as the trigger is pulled,

the tool will drive a fastener every time the contact trip is depressed. This allows

the user to rapidly drive multiple fastener in sequence.





1. Push the (red) trigger lock button down

2. Rotate the (black) selectable trigger button counterclockwise

3. Align the triangular indicator to the desired mode

• ForSequentialMode

• ForContactMode

4. Then push the trigger lock button back up to the un-locked position.



To reduce risk of serious injury from accidental actuation when

attempting to adjust depth, ALWAYS:

• Disconnect air supply and engage trigger

lock.

• Avoidcontactwithtriggerduringadjustments.

The depth that the fastener is driven can be adjusted

using the depth adjustment wheel (G).

The depth of

drive is factory adjusted. Test drive a fastener and

check depth. If a change is desired:

1. To drive the nail shallower, rotate the depth

setting wheel (G) to the left.

2. To drive a nail deeper, rotate the depth setting

wheel (G) to the right.

The adjustment knob has detents every full turn. Test drive another fastener and check

depth. Repeat as necessary to achieve desired results. The amount of air pressure

required will vary depending on the size of the fastener and the material being fastened.

Experiment with the air pressure setting to determine the lowest setting that will

consistently perform the job at hand.

Air pressure in excess of that required can cause premature wear and/

or damage to the tool.













1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 50 51

Comments to this Manuals

No comments

Porter-Cable FC350B Use and Care Manual Page 10

Comments to this Manuals

Related products and manuals for Nail Gun Porter-Cable FC350B