InstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces below and retain for futu
10Remove finger from trigger when not driving fasteners. Never carry tool with finger on trigger: tool will fire a fastener if safety is bumped.Keep f
11CLEAN AND INSPECT DAILYDisconnect tool from air supply before cleaning andinspection. Correct all problems before placing the tool back in use.Wipe
122. Tool does nothing or Inadequate air supply. Verify adequate air supply.operates sluggishly. Inadequate lubrication. Put 5 or 6 drops of oil into
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des
2PORTER✦✦CABLEPorter-Cable Corporation4825 Highway 45 NorthJackson, TN 38305Date of Manufacture:___________________________Fecha de fabricación:, Date
3indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.indicates a potentially hazardous situation
41. Read and understand tool labels andmanual. Failure to follow warnings couldresult in DEATH or SERIOUS INJURY. Fig. 1.2. Operator and others in wor
5Fig. 8Fig. 9Fig. 10Fig. 7Fig. 11Fig. 12Fig. 139. Do not connect tool to pressure whichpotentially exceeds 200 PSI (13.7 BAR).10. Only use air hose th
621. Remove finger from trigger when notdriving fasteners. Never carry tool with fingeron trigger. In “Contact Actuation Mode” toolwill fire a fastene
7Employer must enforce compliance with the safety warningsand all other instructions contained in this manual.Keep this manual available for use by al
8Never point tool at yourself or others.Always connect tool to air supply before loading fasteners (Fig. 18).Do not load fasteners with trigger or saf
9FASTENER GUIDEA Fastener Guide (A) Fig. 23 and 24,is factory installed on ModelFN250A. The Guide is held in placewith a bolt and nut (B) Fig. 23 and2
Comments to this Manuals