Porter-Cable FR350B Use and Care Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 51
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7 - ENG


A. Exhaust deflector
B. Selectable trigger
C. Air Inlet with quick
connect coupler
D. Magazine
E. Nail stop
F. Safety contact trip
with No-mar pad
G. Depth adjustment wheel
H. Pusher release
I. Pusher
J. Trigger lock button
k. Mode selector button

         
         


Keep fingers AWAY from the trigger when not driving fasteners to avoid
accidental actuation. Never carry a tool with finger on the trigger. In bump action mode
(contact actuation mode), the tool will drive a fastener if the contact trip is bumped
while the trigger is depressed.
The FR350B is equipped with a selectable trigger. This trigger allows the operator to
select either single sequential action trigger mode or bump action trigger mode. In
accordance with the ANSI Standard SNT-101-2002, the trigger is assembled in the
single sequential action trigger mode. To change the trigger mode, see 
instructions in the Operation section of the manual. The selectable trigger also has a
trigger lock button to keep the trigger locked at all times when the tool is not in use.

The tool is equipped with a 1/4" (6.4 mm) male quick connector coupling. A 3/8"
(9.5mm)malequickconnectorcouplingisavailablefromPORTER-CABLEandmaybe
used when a 1/4" (6.4 mm) supply line is not available.
 A 3/8" (9.5 mm) supply line (and fittings) are required for maximum tool
performance.
Always use couplings that relieve all pressure from the tool when it is
disconnected from the power supply. Always use hose connectors that shut off air
supply from compressor when the tool is disconnected.
A
F
K
I
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 50 51

Comments to this Manuals

No comments