Porter-Cable FR350B Use and Care Manual download pdf (Page 9)

9-ENG

1. Read all  before using tool.

2. Connect the air supply to the tool.

3. Insert fasteners (L) into T-slot (K) on end cap of magazine (J) past the nail stop (E).

 Magazine will hold two full fastener strips.

4. Pull pusher (I) back until the nail stop (E) falls behind the fasteners.

 Do not allow the pusher to snap

forward against the nail strip, allowing this

to happen could damage the nail collation.

 This tool has a low nail lock out

device which will not allow the tool to drive

fasteners when the fastener quantity in the

magazine is reduced to four. When unload-

ing and loading the magazine always make

sure these four nails have been removed

from the magazine. If the nails are not

removed from the magazine and the tool is

reloaded and actuated, the nails will cause

the tool to jam.



To reduce the risk of injury,  wear proper eye ANSI Z87.1

(CAN/CSAZ94.3)andhearingprotectionANSIS12.6(S3.19)whenoperatingthistool.

The tool can be actuated using one of two modes: single sequential actuation trigger

mode and contact actuation trigger mode.





Allow the tool to recoil off the work

surface after actuation. If the contact trip remains

depressed a nail will be driven each time the trigger is

released and pulled, which could result in accidental

actuation, possibly causing injury.

The sequential actuation trigger’s intended use is

for intermittent fastening where accurate fastener

placement is desired.





1. Depress the contact trip firmly against the work

surface.



























1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 50 51

Comments to this Manuals

No comments

Porter-Cable FR350B Use and Care Manual Page 9

Comments to this Manuals