Porter-cable 7564 User Manual

Double InsulatedPortable Electric DrillInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers

10TO INSTALL AUXILIARY HANDLEAn auxiliary handle (C) Fig. 2, is supplied with some models. This handlescrews directly into the drill housing providing

11GENERAL DRILLING1. Be sure drill bit is securely gripped in chuck. (See INSTALLING ANDREMOVING DRILL BIT).2. Make sure work is held securely in vise

123. When drilling a large hole, it is easier to first drill a smaller hole and thenenlarge it to the required size.4. The use of a lubricant, such as

13LUBRICATIONThis tool has been lubricated with a sufficient amount of high grade lubricant forthe life of the unit under normal operating conditions.

14PORTER-CABLE LIMITEDONE YEAR WARRANTYPorter-Cable warrants its Professional Power Tools for a period of one year from the date of originalpurchase.

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2Read and understand all warnings and operating instructionsbefore using any tool or equipment. When using tools or equipment, basicsafety precaution

3Some dust created by power sanding, sawing, grinding, drilling,and other construction activities contains chemicals known (to theState of California)

4Read all instructions. Failure to follow allinstructions listed below may result in electric shock, fire and/orserious injury. The term "power t

5d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may resu

61. HOLD TOOL BY INSULATED GRIPPING SURFACES WHENPERFORMING AN OPERATION WHERE THE CUTTING TOOLS MAYCONTACT HIDDEN WIRING OR ITS OWN CORD. Contact wit

7SAVE THESE INSTRUCTIONS!SYMBOL DEFINITIONV ... voltsA ... amperesHz ... hertzW ...

8EXTENSION CORD SELECTIONIf an extension cord is used, make sure the conductor size is large enough toprevent excessive voltage drop which will cause

91. DISCONNECT TOOL FROM POWER SOURCE.2. The three-jaw chuck is designed for self-centering of the drill bit. Openchuck jaws by turning outer sleeve c