Porter-cable H1000IS-W User Manual download pdf (Page 19)

19- ENG

A01296

4. Voltage sensitive equipment should be the last equipment connected to the

generator. Plug voltage sensitive appliances such at TV's, VCR's, micro-

waves, ovens, computers, and cordless telephones into a UL listed voltage

surge protector, then connect the UL listed voltage surge protector to the

generator.

Failure to connect and operate equipment in this sequence

can cause damage to equipment and will void the warranty

on your generator.

Follow the wattage calculation table in the Wattage Calculation section of

this manual. Overloading the generator will cause power fluctuations and

can damage equipment and appliances.

Porter-Cable Corporation will only be responsible for damage to

customer's equipment when the generator is determined to be defective.

This determination will only be made by an authorized representative of

Porter-Cable Corporation and this decision will be final. Porter-Cable

Corporation reserves the right to inspect the electrical connections at the

customer's site of operation and test the generator for proper operation

before any determination of liability is made. Failure to maintain the

equipment or wiring for inspection will void any claim for damages by the

customer. Porter-Cable Corporation will not be responsible for equipment

damaged as a result of voltage surges, improper operation or improper

installation of the generator.

CONNECTING PROCEDURE FOR RAISING OR SUSPENDING

GENERATOR

Failure to properly connect lifting cables, chains, or straps can

cause properly damage, serious injury or death, and void the

manufacturer’s warranty.

Always use cables, chains, or straps rated at 2000 lbs. working load

or more to raise or suspend generator.

Never operate generator while suspended. This could cause

property damage, serious injury or death.

DO NOT suspend objects other than generator from skyhook.

1. Route cable, chain, or strap through

lift ring as shown. ALWAYS use lift

ring when raising or suspending

generator.

NOTE: Make sure the generator is in a

level position before raising or

suspending to prevent damage.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Porter-cable H1000IS-W User Manual Page 19