Porter-cable H1000IS-W User Manual download pdf (Page 25)

25- ENG

A01296

TROUBLESHOOTING GUIDE

PROBLEM

CAUSE

CORRECTION

Engine will not

start

1. Low on fuel or oil.

2. Ignition switch in "Off"

position.

3. Faulty spark plug.

4. Choke in wrong position.

5. Fuel shut-off valve in

closed position

6. Unit loaded during start-

up.

1. Add fuel or oil.

2. Turn to "ON" position

3. Replace spark plug.

4. Adjust choke accordingly.

5. Open fuel shut-off valve.

6. Remove load from unit.

1. Faulty receptacle.

1. Have Service Center

replace.

2. Circuit breaker kicked

out.

2. Depress and reset.

3. Defective capacitor.

3. Have Service Center

replace capacitor.

4. Faulty power cord.

4. Repair or replace cord.

5. GFCI switch breaker

kicked out (if equipped)

5. Depress and reset

7. Spark plug wire loose.

7. Attach wire to spark plug.

No electrical

output

1. Overload

1. Reduce load.

2. Faulty cords or

equipment

2. Check for damaged, bare,

or frayed wires on

equipment. Replace.

Repeated

circuit breaker

tripping

1. Generator overloaded.

1. Reduce load.

2. Insufficient ventilation.

2. Move to adequate supply

of fresh air.

Generator

overheating

1. Faulty solenoid

1. Have Service Center

replace.

2. Faulty idle control switch

2. Have Service Center

replace.

3. Faulty windings in stator

4. Faulty circuit board

5. Faulty wire harness

3. Have Service Center

replace.

4. Have Service Center

replace.

5. Have Service Center

replace.

DC does not

have power

with the

circuit breaker

depressed

1. Faulty rectifier

2. Faulty windings in stator

3. Faulty wire harness

1. Have Service Center

replace.

2. Have Service Center

replace.

3. Have Service Center

replace.

No auto idle

1 2 ... 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments