Porter-Cable Laminate Trimmer MODEL 7310 User Manual download pdf (Page 17)

3. DISCONNECT TOOL FROM POWER SOURCE.

4. Firmly grasp motor housing being

sure switch is in the “OFF” position.

5. Verify bit is clear of foreign objects

and cord will not “hang up” on any

obstructions.

6. Be sure workpiece is firmly held in

place. Use clamps where necessary to

secure workpiece.

7. Plug in power supply cord. Be alert

to resist starting torque of motor. Turn

motor “ON”.

8. Allow motor to reach “full speed”.

Place base of trimmer on surface to be trimmed and feed into work until bit

pilot contacts base material. When guiding on a previously laminated

surface, always wax or lubricate the area that trimmer will guide against.

NOTE: While operating trimmer with tilt base at any tilt setting other

than “0” degrees, the long side of the base must be kept

perpendicular to the piloting surface to prevent possible work

spoilage.

9. Feed from left to right with a smooth steady motion (See Fig. 13).

10. At completion of trimming operation, turn switch “OFF”. Allow motor to

come to a complete stop before laying trimmer down.

Fig. 12

SUB-BASE

INVERTED

16"

➤

Fig. 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

No comments

Porter-Cable Laminate Trimmer MODEL 7310 User Manual Page 17