Porter-Cable PC1800HV User Manual download pdf (Page 3)

• DO NOT use to pick up explosive dust, or in areas where air contains explosive dust

such as coal, grain, or other combustible material.

• Static shocks are possible in dry areas or when the relative humidity of the air is low.

This is only temporary and does not affect the use of the vacuum. To reduce the

frequency of static shocks, add moisture to the air with a console or installed humidifier.

• DO NOT put any objects into openings. Do not use with any opening blocked; keep free

of dust, lint, hair and everything that may reduce air flow.

• DO NOT ALLOW THE CORD TO HANG OVER THE EDGE OF A TABLE OR

COUNTER OR TOUCH HOT SURFACES. The unit should be placed or mounted away

from sinks and hot surfaces.

• DO NOT place outlet of vacuum near eyes or ears when operating.

• DISCONNECT BATTERY PACK FROM VACUUM BEFORE MAKING ANY

ADJUSTMENTS, CHANGING ACCESSORIES, SERVICING, MOVING, OR

STORING THE VACUUM. Such preventative safety measures reduce the risk of

starting the tool accidentally.

• AVOID ACCIDENTAL STARTING. Be sure the switch is in the OFF position before

inserting the battery pack.

• USE RECOMMENDED ACCESSORIES. Consult the instruction manual for

recommended accessories. The use of improper accessories may cause risk of injury to

persons.

• NEVER LEAVE VACUUM RUNNING UNATTENDED. TURN POWER OFF.

• KEEP YOUR WORK AREA CLEAN AND WELL LIT. Cluttered benches and dark areas

invite accidents.

• AVOID BODY CONTACT WITH GROUNDED SURFACES SUCH AS PIPES,

RADIATORS, RANGES AND REFRIGERATORS. There is an increased risk of electric

shock if your body is grounded.

• DO NOT OVERREACH. KEEP PROPER FOOTING AND BALANCE AT ALL TIMES.

Proper footing and balance enables better control of the vacuum in unexpected

situations.

• USE SAFETY EQUIPMENT. ALWAYS WEAR EYE PROTECTION. Dust mask, non-

skid safety shoes, hard hat, or hearing protection must be used for appropriate

conditions.

• DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON OR OFF. Any tool that

cannot be controlled with the switch is dangerous and must be repaired.

• SERVICE MUST BE PERFORMED ONLY BY QUALIFIED REPAIR PERSONNEL.

Service or maintenance performed by unqualified personnel could result in a risk of

injury.

• WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENT PARTS. FOLLOW

INSTRUCTIONS IN THE MAINTENANCE SECTION OF THIS MANUAL. Use of

unauthorized parts or failure to follow maintenance instructions may create a risk of

electric shock or injury.

• This appliance is intended for household use only.

• The label on your tool may include the following symbols. The symbols and their

definitions are as follows:

V..................volts A ..................amperes

Hz................hertz W..................watts

min ..............minutes ................alternating current

............direct current

o ................no load speed

................Class I Construction ..................earthing terminal

....................(grounded) ..................safety alert symbol

................Class II Construction …/min ..........revolutions or reciprocation

....................(double insulated) ....................per minute

90550095 PC1800HV 4/1/09 1:25 PM Page 3

1 2 3 4 5 6 7 8 ... 35 36

Comments to this Manuals

No comments

Porter-Cable PC1800HV User Manual Page 3

Comments to this Manuals