Tenoning Jig(Model 34-183)INSTRUCTION MANUALPART NO. 1342471 - 02-02-05Copyright © 2005 Delta MachineryTo learn more about DELTA MACHINERY visit our w
10• The objective is to make the parts fit closely together. Maximize the gluing surface by making the tenon as long as possible(approximately 1/2 the
118. Load and secure the workpiece (L) Fig. 31 on thetenoning jig and adjust the jig to perform the third andfourth cosmetic cheek cuts. Connect the m
12EXAMPLES OF MORTISE-AND-TENON JOINTSPosition the wooden stop block (S)Fig. 34 in front of the saw blade toprevent the workpiece from beingtrapped be
13HAUNCHEDTENONCONCEALEDHAUNCHEDTENONMITEREDTENONTENONENDSMITEREDSAWCUTSTHROUGH-WEDGEDTENONBARE FACEDTENONSIMPLE MORTISE AND TENONMORTISECHEEK OFTENON
14TROUBLESHOOTING GUIDEFor assistance with your tool, visit our website at www.deltamachinery.com for a list of service centers or call theDELTA Machi
15A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers,and Delta Authorized Service Stat
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de
2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic
3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
4FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.ADDITIONAL SPECIFIC SAFETY RULES1. DISCONNECT THE POWER SOURCE to the machine bef
5UNPACKING AND CLEANING Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating fromall unpaint
66. Use the supplied 3mm hex wrench to loosen the set screw (M) Fig. 6. Remove the micro-adjustment assembly (N) fromthe tenoning jig (Fig. 7).MNHRPHR
72. Place the tenoning jig guide bar (A) Fig. 12 into the leftmiter slot (D) and slide the tenoning jig back and forth todetermine if it has side-to-s
8Fig. 18OPERATIONADJUSTMENTS1. For rapid adjustment of the work support plate (A) Fig. 19, toward or away from the saw blade, loosen levers (B) and (C
9JGPRSTENONING JIG USEThis jig is intended to perform cheek cuts only. Cheek cutsare made prior to the shoulder cuts, which are made on atable saw usi
Comments to this Manuals