Porter-cable CPFC2TV3525VP User Manual download pdf (Page 12)

12- ENG

N015840

HOW TO USE YOUR UNIT

How to Stop

1. Set the Auto/Off lever to "Off".

Before Starting

Do not operate this unit until you read this instruction manual for

safety, operation and maintenance instructions.

Break-in Procedure

Risk of Unsafe Operation. Serious damage may result if the follow-

ing break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when

the check valve or a complete compressor pump has been replaced.

1. Make sure the Auto/Off lever is in the "Off" position.

NOTE: Pull coupler back until it clicks to prevent air from escaping through the

quick connect.

Plug the power cord into the correct branch circuit receptacle.

(Refer to

Voltage and Circuit Protection paragraph in the Installation section of this

manual.)

3. Open the drain valve (counter-clockwise) fully to permit air to escape and

prevent air pressure build up in the air tank during the break-in period.

4. Move the Auto/Off lever to "Auto" position. The compressor will start.

5. Run the compressor for 15 minutes. Make sure the drain valve is open and

there is minimal air pressure build-up in tank.

6. After 15 minutes, close the drain valve by turning clockwise. The air receiver

will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

Before Each Start-Up

1. Place Auto/Off lever to "Off".

2. Pull the regulator knob out and turn counterclockwise to set the outlet pressure

to zero.

Visually inspect air hose, replace if needed.

4. Attach hose and accessories.

NOTE: The hose or accessory will require a quick connect plug if the air outlet is

equipped with a quick connect socket.

Risk of Flying Objects. Pull the regulator knob out and turn

counter-clockwise to set the outlet pressure to zero when removing hose or

accessories to prevent hose backlash.

Risk of unsafe operation. Firmly grasp air hose in hand when

installing or disconnecting to prevent hose whip.

Risk of unsafe operation. Do not use damaged or worn acces-

sories.

Risk of Bursting. Too much air pressure causes a hazardous

risk of bursting. Check the manufacturer’s maximum pressure rating for air

tools and accessories. The regulator outlet pressure must never exceed the

maximum pressure rating.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 71 72

Comments to this Manuals

No comments

Porter-cable CPFC2TV3525VP User Manual Page 12

Comments to this Manuals

Related products and manuals for Conditioners Porter-cable CPFC2TV3525VP