ESPAÑOL: PÁGINA 13FRANÇAISE : PAGE 2514" AbrasiveCut-Off MachineInstructionManualPart No. 909516 - 02-26-03The Model and Serial No. plate is loca
10MAINTENANCECHANGING THE WHEELDISCONNECT MACHINE FROM POWERSOURCE.1. Rotate the front wheel guard (A) Fig. 21, to the upposition, as shown.2. Press i
11BRUSH INSPECTION AND REPLACEMENTDISCONNECT MACHINE FROM POWERSOURCE.Brush life varies. It depends on the load on the motor.Check the brushes after t
12A complete line of accessories is available from your Porter-Cable·Delta Supplier, Porter-Cable·Delta Factory ServiceCenters, and Porter-Cable Autho
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®, BAMMER®,B.O.S.S.®, Builder
Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with t
3Make sure switch is in “OFF” position before plugging inpower cord. In the event of a power failure, move switchto the “OFF” position.18. NEVER STAND
4A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti
5FOREWORDPorter-Cable Model 1400 is a 14" Abrasive Cut-Off Machine designed to cut ferrous metals. Cutting capacities (at 90°)are: 5-1/4" Di
6UNPACKING AND CLEANINGCarefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating fromall unpainte
7SWITCH LOCKOUTIMPORTANT: When the tool is not in use, the switchshould be locked in the “OFF” position to preventunauthorized use, using a padlock (
8ADJUSTING DOWNWARDTRAVEL OF ABRASIVEWHEELA stop screw (A) Fig. 12, is provided to limit thedownward travel of the abrasive wheel. This adjustmentis m
9OPERATIONSMAKING THE CUTAfter clamping the workpiece securely in the vise, turnthe machine on and allow the motor to come up to fullspeed. Lower the
Comments to this Manuals