Porter-cable PCB370SS User Manual download pdf (Page 17)

OPERATION

Fig. R

REPLACING THE BULB (FIG. S)

1. Use only a 10 watt maximum bulb. Turn the light

switch off and unplug the saw.

2. Turn the old bulb counterclockwise then remove

it. Place a new bulb (1) into socket (2) and turn it

clockwise until it locks into position.

Fig. S

OVERLOAD BREAKER (Fig. R, T)

When the motor is overloaded during operation, the

overload breaker switch (4) will cause the motor to stop

automatically to prevent damage to the motor. Push in

the ON/OFF switch (2) to turn saw OFF, after that push

the ON/OFF switch (2) to ON to start the saw.

Fig. T

VARIABLE SPEED CONTROL AND ON/OFF SWITCH

CAUTION

● For your own safety, always push the switch

“OFF” when the scroll saw is not in use. Also,

in the case of power failure (all of your lights

go out) push the knob “OFF”. Remove the plug

from the power source outlet to avoid accidental

starting.

●

The variable speed control allows greater

versatility to cut a variety of materials such

as wood, plastics, non-ferrous metals, etc.

Depending on the hardness and thickness of

material, the speed should be reduced to allow

the blade teeth to remove cut material from the

kerf.

VARIABLE SPEED CONTROL KNOB (FIG. R)

The variable speed control allows greater versatility to

cut a variety of materials such as wood, plastics, non-

ferrous metals, etc. Depending on the hardness and

thickness of material, the speed should be reduced to

allow the blade teeth to remove cut material from the

kerf.

1. Your saw is equipped with a variable speed control

knob (1). The blade stroke rate may be adjusted by

simply rotating the variable speed control knob (1).

2. Turn the control knob clockwise to increase up to

1,500 strokes per minute (SPM). Turn the control

knob counterclockwise to reduce, down to 500

strokes per minute (SPM).

ON/OFF SWITCH (FIG. R)

1. To turn power ON, press on/off rocker switch (2) to

“ON” position.

2. To turn power OFF, press on/off rocker switch to

“OFF” position.

WORK LIGHT (FIG. R)

1. To turn work light on, press on/off rocker switch (3) to

“ON” position.

2. To turn off work light, press on/off rocker switch to

“OFF” position.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments

Porter-cable PCB370SS User Manual Page 17

Comments to this Manuals

Related products and manuals for Power saws Porter-cable PCB370SS