Porter-Cable CPF6025VP User Manual download pdf (Page 10)

10-ENG

BREAK-IN PROCEDURES

Serious damage may result if the following break-in

instructions are not closely followed.

This procedure is required before the air compressor is put into service. (before the

hose is installed), the check valve is replaced, or a complete compressor pump is

replaced.

The procedure:

1. Make sure the pressure switch lever is in the "OFF" position.

2. Plug the power cord into the correct branch circuit receptacle.

3. Open the drain valve fully to permit air to escape and prevent air pressure build

up in the air tank during the break-in period.

4. Move the pressure switch lever to "ON/AUTO". The compressor will start.

5. Run the compressor for 15 minutes. Make sure the drain valve is open and

there is minimal air pressure build-up in tank.

6. After 15 minutes, close the drain valve.

7. Move the pressure switch lever to "ON/AUTO". The air receiver will fill to cut-

out pressure and the motor will stop. The compressor is now ready for use.

OPERATING PROCEDURES

Daily Start-Up Checklist

1. Before attaching air hose or accessories, make sure the ON/AUTO lever is set to

“OFF” and the air regulator is closed.

2. Attach hose and accessories.

TOO MUCH AIR PRESSURE CAUSES A HAZARDOUS

RISK OF BURSTING. CHECK THE MANUFACTURER'S MAXIMUM

PRESSURE RATING FOR AIR TOOLS AND ACCESSORIES. THE

REGULATOR OUTLET PRESSURE MUST NEVER EXCEED THE

MAXIMUM PRESSURE RATING.

3. Turn the ON/AUTO lever to “AUTO” and allow tank pressure to build. Motor will

stop when tank pressure reaches “cut-out” pressure.

4. Open the regulator by turning it clockwise. Adjust the regulator to the correct

pressure setting. Your compressor is ready for use.

5. Always operate the air compressor in well-ventilated areas free of gasoline or

other combustible vapors. If the compressoris being used to operate a sprayer

DO NOT use near the spray area.

When you are finished:

6. Set the “ON/AUTO” lever to “OFF”.

7. Turn the regulator counterclockwise and set the outlet pressure to zero.

8. Remove the air tool or accessory.

9. Pull ring on safety valve allowing air to bleed from the tank until tank pressure is

approximately 20 psi. Release safety valve ring.

10.Drain water from air tank by opening drain cock valve on bottom of tank.

WATER WILL CONDENSE IN THE AIR TANK. IF NOT

DRAINED, WATER WILL CORRODE AND WEAKEN THE AIR TANK

CAUSING A RISK OF AIR TANK RUPTURE.

11.After the water has been drained, close the drain cock or drain valve. The air

compressor can now be stored.

NOTE

If drain cock valve is plugged, release all air pressure. The valve can then

be removed, cleaned, then reinstalled.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Comments to this Manuals

No comments

Porter-Cable CPF6025VP User Manual Page 10

Comments to this Manuals

Related products and manuals for Air compressors Porter-Cable CPF6025VP