Porter-Cable CPF6025VP User Manual download pdf (Page 14)

14-ENG

CAUSEPROBLEM CORRECTION

Motor will not run or

restart.

Motor overload protection

switch has tripped.

Tank pressure exceeds

pressure switch “cut-in”

pressure.

Wrong gauge wire or length of

extension cord.

Check valve stuck open.

Loose electrical connections.

Possible defective motor or

starting capacitor.

Paint spray on internal motor

parts.

Fuse blown, circuit breaker

tripped.

Pressure release valve on

pressure switch has not

unloaded head pressure.

Let motor cool off and overload

switch will automatically reset.

Motor will start automatically when

tank pressure drops below “cut-in”

pressure of pressure switch.

Check for proper gauge wire and

cord length.

Remove and clean, or replace.

Check wiring connection inside

pressure switch and terminal box

area.

Contact an Authorized Warranty

Service Center for inspection or

replacement, if necessary.

Have checked by an Authorized

Warranty Service Center. Do not

operate the compressor in the paint

spray area. See flammable vapor

warning.

1. Check fuse box for blown fuse

and replace, if necessary. Reset

circuit breaker. Do not use a

fuse or circuit breaker with

higher rating than that specified

for your particular branch circuit.

2. Check for proper fuse; only time

delay fuses are acceptable.

3. Check for low voltage

conditions and/or proper

extension cord.

4. Disconnect the other electrical

appliances from circuit or

operate the compressor on its

own branch circuit.

Bleed the line by pushing the lever

on the pressure switch to the “off”

position; if the valve does not open,

replace it.

Pressure reading on

the regulated

pressure gauge

drops when an

accessory is used.

It is normal for “some”

pressure drop to occur.

If there is an excessive amount of

pressure drop when the accessory

is used, adjust the regulator

following the instructions on page

7.

NOTE: Adjust the regulated

pressure under flow conditions

(while accessory is being used).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Comments to this Manuals

No comments