Porter-Cable CPF6025VP User Manual download pdf (Page 12)

12-ENG

6. Check that the valve disc moves freely inside the check valve and that the

spring holds the disc in the upper, closed position. The check valve may be

cleaned with a strong solvent.

7. Apply sealant to the check valve threads. Reinstall the check valve.

8. Replace the pressure release tube and fitting.

9. Replace the outlet tube and tighten top and bottom nuts.

10.Replace the shroud.

Motor

The motor has an automatic reset thermal overload protector. If the motor

overheats for any reason, the overload protector will shut off the motor. The motor

must be allowed to cool down before restarting. The compressor will automatically

restart after the motor cools.

If the overload protector shuts the motor off frequently, check for a possible voltage

problem. Low voltage can also be suspected when:

1. The motor does not get up to full power or speed.

2. Fuses blow out when starting the motor; lights dim and remain dim when motor

is started and/or is running.

Motor - Wiring Diagram

The motor connection diagram is located on the side of motor.

STORAGE

Before you store the air compressor, make sure you do the following:

1. Review the "Maintenance" section on the preceding pages and perform sched-

uled maintenance as necessary.

2. Set the “ON/AUTO” lever to “OFF”.

3. Turn the regulator counterclockwise and set the outlet pressure to zero.

4. Remove the air tool or accessory.

5. Pull ring on safety valve allowing air to bleed from the tank until tank pressure is

approximately 20 psi. Release safety valve ring.

6. Drain water from air tank by opening drain cock valve on bottom of tank.

WATER WILL CONDENSE IN THE AIR TANK. IF NOT

DRAINED, WATER WILL CORRODE AND WEAKEN THE AIR TANK

CAUSING A RISK OF AIR TANK RUPTURE.

7. After the water has been drained, close the drain cock or drain valve.

NOTE

If drain cock valve is plugged, release all air pressure. The valve can then

be removed, cleaned, then reinstalled.

8. Protect the electrical cord and air hose from damage (such as being stepped on

or run over). Wind them loosely around the compressor handle. (If so equipped)

Store the air compressor in a clean and dry location.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

No comments

Porter-Cable CPF6025VP User Manual Page 12