Porter-Cable CPF6025VP User Manual download pdf (Page 8)

8-ENG

INSTALLATION

Location of the Air

Compressor

Locate the air compressor in a clean, dry, and well-ventilated area. The air filter

must be kept clear of obstructions which could reduce air flow to the air

compressor. The air compressor should be located at least 12" away from the wall

or other obstructions that will interfere with the flow of air. The air compressor head

and shroud are designed to allow for proper cooling. If humidity is high, an air filter

can be installed on the air outlet adapter to remove excessive moisture. Follow the

instructions packaged with the air filter for proper installation.

Lubrication and Oil

This unit needs no lubrication or oiling.

Extension Cords

To avoid voltage drop, power loss, and overheating to the motor, use extra air hose

instead of an extension cord. Low voltage can cause damage to the motor.

If an extension cord must be used:

• use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot

receptacle that will accept the plug on the extension cord.

• make sure the extension cord is in good condition.

• the extension cord should be no longer than 50 feet.

• the minimum wire size is 12 gauge (AWG). (Wire size increases as gauge

number decreases. 10 AWG and 8 AWG may also be used. DO NOT USE 14

AWG or 16 AWG.)

Installing Wheels, and Rubber Feet (Fig. 2)

THE WHEELS AND HANDLE DO NOT PROVIDE

ADEQUATE CLEARANCE, STABILITY OR SUPPORT FOR PULLING

THE UNIT UP AND DOWN STAIRS OR STEPS. THE UNIT MUST BE

LIFTED, OR PUSHED UP A RAMP.

It may be necessary to brace or support one end of the

outfit when attaching the wheels and the rubber feet, because the air

compressor will have a

tendency to tip.

1. Place shoulder bolt (C) through

wheel (B) and position it into

the bottom hole of the mount-

ing bracket (protruding hub to

the inside). Thread nut (A)

onto shoulder bolt and tighten

firmly with a 9/16” wrench.

Repeat to install second wheel.

2. Attach the rubber feet (D) to the

bottom of the wheel bracket

using the screws (E) provided.

Fig. 2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Comments to this Manuals

No comments

Porter-Cable CPF6025VP User Manual Page 8

Comments to this Manuals

Related products and manuals for Air compressors Porter-Cable CPF6025VP